Monogram ZKMV Installation Instructions Manual page 3

UNIFICATION BRACKET INSTALLATION
the four ¼" hex head screws. ( 2 per unit)
Access
Cover
of the installation, drive two 1/4" hex head screws.
These screws will enhance attachment of mullion trim.
Repeat on the second access cover.
Access Cover
Hole Locations
front bracket is installed.
TOP UNIFICATION
screws.
Assemble the bracket to the middle screws and
reassemble the rear screws.
Tighten screws to tie units together.
Unification
Bracket
Front of appliances
31-1000728 Rev. 0
Installation Instructions
1/4" Hex
Screws
BOTTOM BACK UNIFICATION
Loosen the two bottom screws of rear access covers of
both units and remove the top screws.
Hang the unification bracket to the bottom screws and
reassemble the screws at the top.
Tighten screws to unify both refrigerators.
BOTTOM FRONT UNIFICATION
Install the bottom front unification bracket using a 3/8"
driver (4 screws).
Make sure the two screws you added to the side of the
front access cover face each other when reinstalling
lower access covers.
Reinstall the two front lower grille covers by securing
with the four ¼" hex head screws.
After joining unit together, plug power cords into outlet
for both units.
3
Unification
Bracket
Unification Bracket