Bosch PUG AA Series User Manual And Installation Instructions page 16

en Installation instructions
16.6 Inserting the hob
Adjust the hob in the front section of the built-in
1.
niche.
Insert the hob in the cut-out.
2.
Seal the tile joints on tiled work surfaces with silic-
3.
one rubber.
Note: Do not kink or trap the connection cable, and
keep it away from sharp edges and hot parts.
16.7 Connecting the appliance
Requirement: Observe the connection data on the rat-
ing plate.
Only connect as shown in the circuit diagram:
1.
– BN: Brown
– BU: Blue
– GN/YE: Green and yellow
Check that the appliance is ready for operation: If
2.
, or appears on the appliance's display,
the appliance is not connected correctly. Disconnect
the appliance from the power supply and check the
power cord connection at the mains supply.
16
16.8 Special combinations
If you install the hob above an oven made by another
brand, use a wooden partition floor.
16.9 Removing the appliance
ATTENTION!
Tools may damage the appliance.
Never prise out the appliance from above.
▶
Disconnect the appliance from the mains power
1.
supply.
Push out the hob from below.
2.