Bosch PUG AA Series User Manual And Installation Instructions page 15

Hide thumbs Also See for PUG AA Series:
Table of Contents

Advertisement

16.5 Preparing the fitted units
Mark the unit cut-out in accordance with the installa-
1.
tion diagram.
Ensure that the angle of the cut surface to the
worktop is 90°.
After making the cut-outs, remove any shavings.
2.
Seal the cut surfaces with heat-resistant material.
3.
Ventilation
To guarantee that the appliance works correctly, the
hob must be sufficiently ventilated. The ventilation in
the lower section of the appliance requires a sufficient
supply of fresh air. Therefore, if required, adjust the
units for this purpose.
Maintain a minimum clearance between the rear of
1.
the unit and the kitchen wall.
Ensure that an opening at the top of the rear of the
2.
unit is unobstructed.
If the clearance from the back wall of the unit is less
3.
than 20 mm, create an opening on the underside.
Do not hermetically seal the lower base.
4.
Note: If the appliance is installed in an island unit or in
another location that is not described here, guarantee
that the hob is ventilated appropriately.
Installation above a drawer
¡ In order to guarantee good ventilation, the clearance
between the surface of the worktop and the upper
area of the drawer must be 65 mm.
Installation above an oven
¡ To ensure good ventilation, the clearance between
the top of the worktop and the surface of the oven
front must be 30 mm and the minimum clearance
between the oven and hob must be 5 mm.
¡ If the clearance between the hob and the oven
needs to be increased, refer to the installation in-
structions for the oven.
Installation instructions en
15

Advertisement

Table of Contents
loading

Table of Contents