VTech Marble Rush Sky Elevator Set Instruction Manual page 5

Battery Removal and Installation -- Train
1. Make sure the unit is turned Off.
2. Find the battery cover located on the
back of the unit, use a screwdriver
to loosen the screw and then open
the battery cover.
3. Remove old batteries by pulling up
on one end of each battery.
4. Install 3 new AAA (LR03/AM-4)
batteries following the diagram
inside the battery box. (For best performance, alkaline
batteries or fully charged Ni-MH rechargeable batteries are
recommended.)
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
5