Ir Sensor; Batteries And Cleaning - Philips 55PUG8808 User Manual

input, release the  key to start the search. It might
take some time for the results to appear.
3 - In the list of search results, you can select the
item you want.
3.4

IR Sensor

The TV can receive commands from a remote control
that uses IR (infrared) to send commands. If you use
such a remote control, always make sure you point
the remote control at the infrared sensor on the front
of the TV.
 Warning
Do not put any objects in front of IR sensor of the TV
as it may block the IR signal.
3.5

Batteries and Cleaning

Replace batteries
Refer to the Quick Start Guide in your product
package for detailed information about the remote
control batteries.
If the TV does not react to a button being pressed on
the remote control, the batteries might be dead.
To replace the batteries, open the battery
compartment on the back of the remote control.
1 - Slide the battery door in the direction shown by
the arrow.
2 - Replace the old batteries with new batteries.
Make sure the + and the - ends of the batteries line
up correctly.
3 - Reposition the battery door and slide it back until
it clicks.
• Remove the batteries if you are not using the remote
control for a long time.
• Safely dispose of your old batteries according to the
end of use directions.
Cleaning
Your remote control is treated with a scratch-resistant
coating.
To clean the remote control, use a soft damp cloth.
Never use substances such as alcohol, chemicals or
household cleaners on the remote control.
10