Replacing The Filter; Removing The Filter; Turning On And Heating Up; Making Coffee Using Coffee Beans - Barazza 1CFEVG Instruction Manual

10. Press the
The appliance begins delivering hot water
and the message "PLEASE WAIT" is di-
splayed.
After the flow of hot water stops, the ap-
pliance automatically resets to "READY"
status.
Replacing the filter ("Filter
Reset")
When "REPLACE FILTER" is displayed or after
2 months of use (see date indicator), the filter
must be replaced:
1. Remove the exhausted filter;
2. Remove the new filter from the packaging.
3. Slide the pointer of the date indicator (see
fig. 28) until the months of use are displayed
(the filter lasts about 2 months).
4. Insert the filter in the water tank and press it
until it touches the bottom of the tank (see
fig. 28).
5. Fill the water tank and insert in the coffee
maker;
6. Turn the cappuccino maker outwards and
place a container underneath (min. capacity
100 ml).
7. Press the button (B6) to enter the menu;
8. Press the
RESET NO" is displayed.
9. Press the
RESET YES" is displayed.
10. Press the
11. "HOT WATER PRESS OK" is displayed.
12. Press the
pliance begins delivering hot water and the
message "PLEASE WAIT " is displayed. After
the flow of hot water stops, the appliance au-
tomatically resets to "READY" status.

Removing the filter

If you want to use the appliance without a filter,
you must remove it and notify the appliance of
its removal as follows:
1. Press the button (B6) to enter the menu.
2. Press the
STALL FILTER" is displayed.
button (B9)
button (B7) until "FILTER
button (B8) until "FILTER
button (B9) to confirm.
button (B9) again. The ap-
button (B7) until "UNIN-
3. Press the
automatically resets to "READY" status.
TURNING ON AND HEATING
UP
Each time the appliance is turned on, it performs
an automatic preheat and rinse cycle which can-
not be interrupted. The appliance is ready for use
only after completion of this cycle.
Danger of burns! During rinsing, a little
hot water flows from the coffee spouts.
Avoid contact with splashes of water.
To turn the appliance on, turn the knob
(to the right or left) (fig. 5). "HEATING UP PLE-
ASE WAIT" is displayed.
After heating, the message "RINSING "PLEASE
WAIT" is displayed. As well as heating the boiler,
the appliance also heats the internal circuits by
circulating hot water.
The appliance is at temperature when the mes-
sage "READY STANDARD TASTE" is displayed.
MAKING COFFEE USING
COFFEE BEANS
1. The appliance is preset to make coffee with
a standard taste. You can also choose cof-
fee with an extra-light, light, strong or ex-
tra-strong taste.
To choose the required taste, press the
button (B2) (fig. 6). The required coffee taste
is displayed.
2. Place 1 cup under the spouts to make 1 cof-
fee (fig. 7) or 2 cups for 2 coffees (fig. 8).
Lower the spouts as near as possible to the
cup for a creamier coffee (fig. 9).
3. Press the
coffee, the
coffee and the
fee (fig. 10). To make 2 coffees, press the
button twice (within 2 seconds).
To change the quantity of coffee the ap-
pliance delivers automatically into the cup,
10
button (B9). The appliance
button (B3) to make a short
button (B4) for a standard
button (B5) for a long cof-
(A7)