Table of Contents
Advertisement
Connecting the Exterior Hoses
☐
Install the curved end of the 1 in intake hose assembly onto the spigot on
the side of the compressor. Direct the hose upwards and secure it using the
supplied hose clamp (Figure 43).
☐
Apply split loom, or equivalent hose protection (not supplied), to the 3/4 in ×
120 in and 3/8 in × 120 in hoses.
☐
Apply the supplied split loom to the 1/4 in × 125 in PTFE tube.
☐
Connect the 120 in PTFE tube to the 90° push-to-connect fitting on the side of
the compressor.
☐
Connect the 90° end of the 3/4 in hose to the compressor discharge fitting
on the rear of the compressor. Direct the hose toward the driver side of the
vehicle.
VMAC - Vehicle Mounted Air Compressors
VMAC Technical Support: 888-241-2289
VMAC Knowledge Base: kb.vmacair.com
Figure 43 — Install intake hose
35
Advertisement
Table of Contents
