Programming A Recording (Without 'Videoplus') - Philips 14PV210/01 Service Manual

e
Confirm with the button. Your programming details
OK
will then appear on the TV screen.
TIMER PROGRAMMING
DATE PROG. START
,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,
15 xxx 15:36 15:50 -
ã Exit:
« press TIMER
D If VIDEOPlus+ does not recognise the TV channel,
' ' will appear on the TV screen. Instead of
P??
' ', you can select the programme number you
P??
want with the number buttons
D If '
Code error
means you entered an incorrect PlusCode number
or the incorrect date. Correct your instructions or
end with the TIMER k
D If '
Daily error
date was incorrectly entered.
D Under '
VPS/PDC
button to switch 'VPS or PDC' on or off.
D Under '
', use the
LP
select the recording speed 'SP' or 'LP'.
D The TIMER lamp on the front of the set will light up
when one or more of the TIMER blocks are
occupied.
D When you are recording, the red recording light at
the front of the TV-VIDEO Combi will be alight.
D If the end of the cassette is reached during a
recording, the TV-VIDEO Combi automatically ejects
the cassette.
D If you forget to load a cassette, '
will appear.
D If you inserted a cassette with erase protection
when you want to start a recording, the cassette will
be ejected.
f
Confirm with the button.
OK
E '
Press STANDBY to start recording
will appear on the screen. If you have programmed a
recording that should start within the next few minutes,
confirm with the STANDBY m
programmed a recording that will start at some later point
in time, confirm with the
VPS
END LP PDC REP.
* ONCE
Start:
press è
.
0-9
' appears on the TV screen, this
button.
' appears on the TV screen, the
', use the or
P rB AP q
or button to
P rB AP q
No cassette
button. If you have
button.
OK
D A programmed recording can only start, when the
machine is switched to standby.
g
If you confirmed with the
the TIMER k button.
Programming a recording
(without 'VIDEOPlus')
a
Press the
TIMER k
b
Select the line '
Timer programming
buttons P rB or
SqC button.
TIMER PROGRAMMING
DATE PROG. START
,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,
-- --
ã Exit:
« press TIMER
c
Select a free TIMER block with the
Press the button.
OK
TIMER PROGRAMMING
DATE PROG. START
,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,
15 xxx
'
ã Exit:
« press TIMER
d
Select the entry field with the
button.
e
Enter information with the buttons
' with the digit buttons
button, exit the menu with
OK
button on the remote control.
' with the
AP q and confirm with the
VPS
END LP PDC REP.
--:-- --:-- - - -----
Start:
press è
P pAB
VPS
END LP PDC REP.
15:36 15:50 - * ONCE
Start:
press è
DSr or SqC
or
P rB
.
0-9
button.
or
AP q
17