Viking E24W Instructions For Use page 3

EN
VIKING E24W 24000mAh - instruc�ons for use
Thank you for choosing a VIKING product.
Please refer to the technical specifica�ons of each model in the user manual or on the website www.best-power.cz
How to use:
Please check that the device is fully charged before using the power bank. The blue LEDs indicate the capacity and
charging status.
Switching on/off
- To switch on the power bank, briefly press the "ON/OFF" bu�on.
- The power bank will automa�cally switch off a�er about 30s of inac�vity.
Ba�ery capacity:
- The ba�ery charge status is indicated by 4 LED light indicators as follows. If only one LED is lit, the power bank is
charged to 0-25%. If 4 LEDs are lit, the power bank is charged to 75-100%. If one LED is blinking, the power bank is
discharged.
Charging a solar power bank with solar energy:
- Make sure that the solar panel faces directly towards the sun.
- Charging will start automa�cally.
- The maximum power of the solar panel is 1.3W
- The power of the solar panel depends on the intensity of the solar light.
- A green LED on the front of the power bank indicates that charging is in progress.
- The power bank con�nuously recharges its capacity even in ar�ficial light and indirect sunlight, but with reduced
power.
Powerbank as part of a set with solar panel VIKING SP7W:
A�ach the power bank to the solar panel ba�ery pack, with the solar panel of the power bank facing upwards. The
power bank connects to the panel with magnets. If the solar panel is open in the sun, it will automa�cally start
charging.
Charging a solar power bank from an external power source:
- The power bank can be charged using a USB-C, micro USB and Lightning cable.
Charging other devices:
- Connect the power bank to the device being charged.
- Mul�ple devices can be charged at the same �me.
- Charging starts automa�cally.
- If charging does not start automa�cally, turn on the power bank manually.
Using wireless charging
- Make sure the device you are charging supports wireless charging.
- Before using wireless charging, turn on the power bank and make sure that the LED at the output and input ports
of the power bank marked with lightning is green. If it is red, turn the power bank off and back on.
- Place the device to be charged on the back of the power bank in the area marked for wireless charging.
- The device to be charged should not be more than 8mm from the power bank.
- Charging will start automa�cally. The LED at the output and input ports of the power bank marked with a flash will
flash blue if 5W wireless charging is used and green if 10W wireless charging is used.
- If the LED on the back is red, wireless charging cannot be used. Either the device being charged is fully charged, or
a foreign object is preven�ng wireless charging, or the device being charged is incorrectly posi�oned on the power-
bank.
LED flashlight control:
- Press and hold the "ON/OFF" bu�on un�l the LED light turns on. Press and hold the "ON/OFF" bu�on again to turn
off the LED light.
Warning:
1. Do not disassemble the device or its accessories.
2. Do not modify, disassemble, open, puncture, remove or otherwise tamper with the rechargeable ba�ery inside the device.
3. Protect from fire, prolonged direct sunlight, and other heat sources to prevent overhea�ng and damage to the device, including the ba�ery inside the device.
4. Protect from contact with water and wet objects, especially when using the equipment.
5. Protect from high voltage equipment.
6. Do not throw or shake the equipment.
7. Do not use chemical cleaners to clean the equipment.
8. This equipment is not intended for use by persons (including children) whose physical, sensory or mental disability or lack of experience or knowledge prevents them from using
the equipment safely.
9. When the device is not in use, secure the sockets with safety plugs (if the device has them).
10. Stop using this equipment immediately if it is damaged in any way.
11. For safety reasons, use only the original charger and cables designed for this device for charging.
12. In case of igni�on, do not use a water ex�nguisher! If necessary, only a dry powder ex�nguisher is suitable for the product.
13. This product is intended for emergency power supply of electrical appliances only. It is not a full replacement for the permanent DC or AC power supply of household appliances.
14. This device is designed to supply power to Class II (double insulated) appliances.
15. Altering, damaging or obscuring the logo and nameplate on the equipment is strictly prohibited.
16. When installing the device (if possible), use suitable tools to �ghten all screws.
17. It is strictly forbidden to operate under voltage during installa�on (if possible).
Protect from children!
Ignoring the following safety instruc�ons may result in fire, electric shock, or damage to the generator.
Recycling:
Do not dispose of the product or ba�eries at the end of their useful life as unsorted municipal waste, use sorted waste collec�on points. For more informa�on about recycling this
product, contact your local municipality, household waste management organiza�on, or the point of sale where you purchased the product.
The liability for product defects is 24 months according to the Consumer Protec�on Act No. 634/1992.
The ba�ery life is 6 months, when the real (nominal) power does not drop below 80% of the ba�ery's nominal power under normal and proper use.
The LED life�me is 6 months, when, under normal and correct use of the LED lights, at least 80% of the total number of LEDs in the device are guaranteed to be lit.
The seller's claim for liability for defects is ex�nguished in the event of:
- Damage due to improper use or use of the equipment in unsuitable condi�ons.
- Failure to comply with the technical specifica�ons and instruc�ons for use of the equipment.
- A�empts by the user to repair, assemble or dismantle the equipment in an unprofessional manner.
- Damage to the equipment or any part thereof due to natural elements, e.g. lightning, water, mechanical damage, etc.
- Damage to the equipment or any part thereof due to unprofessional handling.
BONA SPES s.r.o., Řepčín 250, Olomouc 77900, Czechia, IČO: 03476774, DIČ: CZ03476774, VAT No.: 03476774,
Distribu�on of the VIKING and TOPDON brands is provided by the company:
+420 777 109 009, www.best-power.cz, info@best-power.cz
8
7
1
2
4
3
1. "ON/OFF" bu�on
2.USB-A output
3. Lightning input
4. Micro USB input
5. USB-C output/input
6. USB-A output
7. Ba�ery capacity status LEDs
8. Solar charging LED
9. wireless charging LED
BONA SPES s.r.o.
6
5
9
MADE IN CHINA