Advertisement
Indication
Description
Parameter 13: Class 100; Instance 1; Attribute 117
Open limit
It defines the end of travel setting in Open direction:
0= open limit by torque
1= open limit by position
Parameter 14: Class 100; Instance 1; Attribute 118
Close limit
It defines the end of travel setting in Close direction:
0= close limit by torque
1= close limit by position
Parameter 15: Class 100; Instance 1; Attribute 119
Nominal torque
Nominal torque of the motor:
0= 63 Nm
1= 125 Nm
2= 250 Nm
3= 500 Nm
4= 1000 Nm
5= 2000 Nm
Parameter 16: Class 100; Instance 1; Attribute 120
LED colour code
It defines the colour of the LED indicating the Fully Open and
Fully Close position:
0: Open: LED=green;
Close: LED=red
1: Open: LED= red;
Close: LED= green
6.7 DeviceNet configurable parameters
For correct communication and identification of the actuator it is required to configure the correct MACID and Baud Rate.
Indication
Description
Parameter 17: Class 3; Instance 1; Attribute 1
MACID
The MACID to assign to the device
Parameter 18: Class 3; Instance 1; Attribute 2
Baud Rate
The Baud Rate to assign to the device
MSB-LSB Address
BCD Rotary switches
BCD Rotary switch
ENTER pushbutton
OM11 - EPI
Installation & Maintenance Instructions
6.8 EDS file
The DeviceNet interface module is provided with an Electronic Data Sheet (EDS) file. The EDS file
is DeviceNet specific and provides information about the device configuration data. The EDS file is
used by the DeviceNet configuration tool in order to get all the information necessary to the device
configuration and to the access and alter the configurable parameters of the EPI
7. Local settings
The DeviceNet interface module is equipped with 3 on-board selector switches to allow the
operator configuration of both the MACID and the Baud Rate of DeviceNet communication.
To access the on-board interface on the DeviceNet interface module it is necessary to follow the
procedures explained in 'EPI
and configuration' and then follow the procedures described in the next paragraphs.
7.1 On-boards interface
The on-board interface is equipped with the following switches and indications.
DATA_RATE
CNF_OK LED
ON_CFG LED
ENA_CFG switch
Pentair reserves the right to change the contents without notice
DeviceNet interface
2
Direction
R/W
R/W
Only read
R/W
Direction
R/W
R/W
Quarter-turn Electric Actuator IOM' at Chapter 6: 'Actuator settings
2
Data Type
Range
Default
Integer
0-1
1
Integer
0-1
1
Integer
0-5
-
Integer
0-1
0
Data Type
Range
Default
Unsigned
0-63
63
Unsigned
0-2
0
actuator.
2
E.U.
-
-
-
-
E.U.
-
-
page 7
Advertisement
