Safety Information; Pre-Assembly; Planning Assembly - Home Decorators Collection 64108 Use And Care Manual

Important Safety Instructions
WARNING:
□ Do not use this set on soft ground.
□ Do not stand or allow children to stand on the assembled chairs, sofa, fire
pit, or tank housing.
□ After assembly, verify that all hardware connections are secure before
putting the product into use.
CAUTION:
□ READ ALL INSTRUCTIONS BEFORE BEGINNING ASSEMBLY AND BEFORE
USE. Failure to do so may result in faulty assembly and/or potential injury.
□ Use these furnishings only for their intended use as described in these
instructions.
□ Do not use sharp edges such as a knife or scissors when removing the
protective material, as it may damage the product.
READ ALL INSTRUCTIONS BEFORE USE
When using these furnishings, always follow basic precautions, including the following:
Read all instructions before using this set.
To reduce the risk of injury to persons:
□ Do not use this set on soft ground.
□ Do not stand or allow children to stand on the assembled chairs, sofa, fire pit, or tank housing.
□ After assembly, verify that all hardware connections are secure before putting the product into use.

Pre-assembly

PLANNING ASSEMBLY

Before beginning assembly of each piece of the set, completely empty contents of the relevant cartons and remove all packing material.
Make sure all parts and hardware are present. If any parts are missing, contact the Customer Service Team.
Before installing the unit, check the minimum clearances to combustibles below to ensure that the surrounding area is properly sized for
the installation.
SELECTING A LOCATION
□ Choose an area that is level and clear of debris.
□ The area should be large enough to comfortably
accommodate the full set of fire pit table,
seating, and tank housing without blocking
entrances or exits from the immediate area or
adjacent buildings.
□ Ideally, locate the fire pit table in an open area
without a roof or overhang.
□ Minimum clearances from the fire pit burner to
combustible materials are: 48 in. (4 ft.) from all
sides and 72 in. (6 ft.) overhead.
IMPORTANT:
Do not tighten hardware completely until instructed to do so. Then, after final
alignment, securely fasten all nuts and bolts. Perform periodic checks to
make sure the hardware is secure and adjust if needed.
NOTE:
□ Never use a power tool to assemble or adjust hardware connections.
Overtightening hardware can strip the threads.
NOTE:
Save these instructions.
Minimum
48 in. clearance
from sides to any
combustible material
3
Please contact 1-800-986-3460 for further assistance.
Minimum 72 in.
overhead clearance
HOMEDEPOT.COM/HOMEDECORATORS
Minimum
48 in. clearance
from sides to any
combustible material