JOCCA HOME & LIFE 1494 Instruction Manual page 10

EN
1.1. Install the heat pipe assembly (as shown in Fig.1).
-Take out the outer connector assembly and the exhaust pipe
assembly, and remove the plastic bags.
-Insert the heat pipe assembly (the end of the exhaust joint)
into the back panel vent slot (push to the left) and complete
the assembly (as shown in figure 1).
1.2. Installation of window sealing plate components
-Half open the window and mount the window sealing
plate assembly to the window (as shown in Fig.2 and
Fig.3). Components can be placed in horizontal and vertical
direction.
-Pull various components of the window sealing plate
assembly open, adjust their opening distance to bring both
ends of the assembly into contact with the window frame,
and fix various components of the assembly.
-Install the window sealing plate assembly
Notes1: The flat end of the exhaust pipe joints must be
snapped into place.
Notes 2: The pipe cannot be distorted nor has substantial
turning (greater than 45 °). Keep the ventilation of the
exhaust pipe not blocked.
10