JL Audio e112 Owner's Manual page 19

SYSTEM CONNECTION DIAGRAM 1:
One E-Sub to Home Theater Receiver
or Home Theater Preamp/Processor
Most home theater receivers and
preamp/processors provide a single
(mono) subwoofer line-level output.
When connecting a mono subwoofer
output to your E-Sub, you only need
to connect to one of the E-Sub's "Line
Inputs" (Left or Right). Use a good-
quality audio interconnect cable with
RCA-type connectors.
In most cases, you will use the bass
management/crossover features of the
receiver or preamp/processor. This
requires that the E-Sub's "Crossover"
switch is placed in the "Off " position.
WARNING
| E-Sub
RECEIVER / PROCESSOR
PRE OUT
FRONT REAR CENTER
L
FRONT R REAR SUB
L
R
LINE
INPUTS
WARNING! TURN OFF THE E-SUB(S) AND ALL OTHER EQUIPMENT IN THE
SYSTEM BEFORE MAKING OR CHANGING ANY CONNECTIONS!
E-SUB TOP CONTROL PANEL
L
CH. 2 CH. 1
(R) (L)
Grounded
R
Isolated
LINE
HIGH LEVEL INPUTS
OUTPUTS
E-SUB REAR PANEL
Page 19 | EN