Table of Contents
Advertisement
Constant Variable Transmission (CVT) System
WARNING
Failure to comply with the instructions in this warning can result in severe
injury or death.
Do not modify any component of the CVT system. Doing so may reduce its
strength so that a failure may occur at a high speed. The CVT system has
been precision balanced. Any modification will cause the system to be out of
balance, creating vibration and additional loads on components.
The CVT system rotates at high speeds, creating large amounts of force on
clutch components. Extensive engineering and testing has been conducted to
ensure the safety of this product. However, as the owner, you have the
following responsibilities to make sure this system remains safe:
• Always follow all recommended maintenance procedures. See your
POLARIS dealer, or other qualified person, for service and repair assistance.
• This CVT system is intended for use on POLARIS products only. Do not
install it in any other product.
• Always make sure the CVT housing is securely in place during operation.
CVT Drying
There may be some instances when water is accidently ingested into
the CVT system. Use the following instructions to dry it out before
operating. The drain plug is located on the bottom of the CVT cover.
1. Remove the drain plug. Allow the water to drain. Reinstall the
drain plug.
2. Shift the transmission to neutral. Set the parking brake.
3. Start the engine. Apply varying throttle for 10-15 seconds to expel
the moisture and air-dry the belt and clutches. Do not hold the
throttle wide open for more than 10 seconds.
4. Allow the engine RPM to settle to idle speed.
5. Test for belt slippage. If the belt slips, repeat the process.
6. Your vehicle requires service as soon as possible. Your POLARIS
dealer can assist.
NOTICE: Exposure to salt water will cause corrosion to metal components. If
your vehicle is operated in salt water areas, rinse it off frequently
with fresh water.
MAINTENANCE
75
Advertisement
Table of Contents
