ASROCK H410M-H/M.2 SE User Manual page 51

H410M-H/M.2 SE
ODT NOM (B1)
Use this to change ODT (CH B1) Auto/Manual settings. The default is [Auto].
ODT PARK (A1)
Configure the memory on die termination resistors' PARK for channel A1.
ODT PARK (B1)
Configure the memory on die termination resistors' PARK for channel B1.
Advanced Setting
ASRock Timing Optimization
Configure the fast path through the MRC.
Realtime Memory Timing
Configure the realtime memory timings.
[Enabled] The system will allow performing realtime memory timing changes after
MRC_DONE.
Command Tristate
Configure the Command Tristate Support.
Exit On Failure
Configure the Exit On Failure for MRC training steps.
Reset On Training Fail
Reset system if the MRC training fails.
MRC Fast Boot
Enable Memory Fast Boot to skip DRAM memory training for booting faster.
Voltage Configuration
CPU Core/Cache Voltage
Input voltage for the processor by the external voltage refulator.
CPU GT Voltage
Configure the voltage for the integrated GPU.
DRAM Voltage
Use this to configure DRAM Voltage. The default value is [Auto].
47