Wolo SEE-WAY 6050 Operating Instructions

Your choice of a Wolo rechargeable work light is the perfect choice for use at home, boating, camping, roadside
assistance and etc. Wolo manufactures this product with the finest materials. Each light is tested to meet our high
standards before it is packaged, to assure a perfect working light. Our quality workmanship and components
are Wolo's assurance of a product that will give years of dependable service. If you need help using your new
Wolo work light, our technicians are available to
answer your questions, Monday thru Friday, from
9 AM to 4 PM EST at 1-888-550-4676.
IMPORTANT: Read this instruction sheet before
using the work light to ensure safe operation
/ storage. The Lithium-Ion battery will last
hundreds of safe charge / discharge cycles.
Always follow the simple guidelines below and
use the same caution and care that would be
given to an electronic or electrical device.
TO OPERATE WORK LIGHT:
1. Press and release the On/Off button to
turn on.
2. Press and release the Mode button to
select from four (4) different modes:
HIGH BEAM • LOW BEAM • FLASHING
S-O-S and FAST FLASH.
3. Press and release the On/Off button to
turn off.
4. When the battery is fully charged, you
should have approximately 4.5 hours
of work time when using the high beam
and 9.0 hours when using low beam.
TO CHARGE BATTERY:
IMPORTANT: Use only the 110-volt AC charger
or 12-volt power wire with cigarette lighter plug
provided to charge the work light's battery. (The
battery may need to be fully charged before first
use). There are four (4) LED lights on the front panel which shows the user when it is necessary to recharge
the light's battery. When the battery is fully charged the four (4) LEDs are illuminated. The user can check the
battery's charge condition by simply turning on the light.
5. The male plug connected to the charger's wire, is inserted into the socket located in the backside bottom
of the light.
6. Connect the charger to 110-volt AC power source or cigarette lighter plug to 12-volts DC (vehicle's
accessory power outlet).
7. The 110-volt AC charger and the 12-volt charger plug have a LED indicator, while charging it will illuminate
red and will change to green when the battery is fully charged. Allow approximately 4-5 hours charge
time if the battery is fully discharged and the work light does not turn on.
NOTE: When using the 110-volt AC charger, you may feel it gets slightly warm to the touch; that is normal.
OPERATING INSTRUCTIONS FOR
WOLO SEE-WAY
15-WATT LED WORKLIGHT
Fold-away
Handle
On / Off
Magnet
Base
12-volt
power charger
MODEL 6050
TM
Male
Plug
Male
Plug
LED
Charge
Indicator
110-volt
AC charger
Battery Level
Indicator
Mode:
• High Beam
• Low Beam
• Flashes S-O-S
• Fast Flash
LED
Charge
Indicator