Wolo SEE-MORE 6000 Operating Instructions

Your choice of a Wolo rechargeable work light is the perfect choice for use at home, boating, camping, roadside
assistance and etc. Wolo manufactures this product with the finest materials. Each light is tested to meet
our high standards before it is packaged, to assure a perfect working light. Our quality workmanship and
components are Wolo's assurance of a product that will give years of dependable service. If you need help using
your new Wolo work light, our technicians are available
to answer your questions, Monday thru Friday, from
9 AM to 4 PM EST at 1-888-550-4676.
IMPORTANT: Read this instruction sheet before using
the work light to ensure safe operation / storage. The
Lithium-Ion batteries will last hundreds of safe charge
/ discharge cycles. Always follow the simple guidelines
below and use the same caution and care that would
be given to an electronic or electrical device.
TO OPERATE WORK LIGHT:
1. Press and release the On/Off button to turn on.
2. Press and release the Mode button to select
from three (3) different modes: HIGH BEAM •
LOW BEAM • FLASHING S-O-S.
3. Press and release the On/Off button to turn off.
4. When the batteries are fully charged, you
should have approximately 4 hours of work
time when using the high beam.
TO CHARGE BATTERIES:
IMPORTANT: Use only the 110-volt AC charger or 12-
volt power wire with cigarette lighter plug provided to
charge the work light's batteries. (The batteries may
need to be fully charged before first use).
5. The male plug connected to the charger's
wire, is inserted into the socket located in the
backside bottom of the light.
6. Connect the charger to 110-volt AC power source or cigarette lighter plug to 12-volts DC (vehicle's
accessory power outlet).
7. The LED indicator light located on the front control panel will illuminate RED when charging and will
change to green when the batteries are fully charged. Allow approximately 4 hours charge time if the
batteries are fully discharged and the work light does not turn on.
NOTE: When using the 110-volt AC charger, you may feel it gets slightly warm to the touch; that is normal.
STORING THE WORK LIGHT:
DO NOT STORE THE WORK LIGHT WITH THE BATTERIES FULLY CHARGED FOR LONGER THAN 3 MONTHS.
When storing the work light away for long periods of time without use, drain the batteries down by turning on
the work light for about 5 minutes, before storing. Failure to follow this procedure can result in damage to the
batteries during long-term storage.
OPERATING INSTRUCTIONS FOR
WOLO SEE-MORE™ MODEL 6000
LED 15-WATT LED WORKLIGHT
Fold-away
Handle
On / Off
Magnet
Base
LED Charging Indicator:
Charging - Red
12-volt
Male
power charger
Plug
Mode:
1. High Beam
2. Low Beam
3. Flashes S-O-S
Fully Charged - Green
110-volt
AC charger
Male
Plug