Table of Contents
Advertisement
Malfunction
Drying time is too long.
Water is leaking.
When filling the water
tank, water flows
water left.
Laundry is too damp.
Cause and Troubleshooting
Ambient temperature is lower than 15°C.
Make sure that the ambient temperature is above
▶
15 °C.
Insufficient air circulation at the installation site of
the device.
Ventilate the installation site of the device.
▶
Too little condensed water for automatic self-cleaning
when using the anti-crease function permanently.
Ventilation opening of the device is blocked.
Make sure that the ventilation opening of the device
▶
is kept clear.
Heat exchanger is contaminated.
Perform simple device maintenance on the device.
▶
→ "Device care", page 45
The appliance is not leveled properly.
→ "Adjusting the device", page 16
▶
Water drain hose is not connected correctly.
Make sure that the water drain hose is correctly
▶
connected.
→ "Connect the water drain hose", page 14
The water tank for the anti-crease function is empty.
Fill water tank.
▶
→ "Fill the water tank", page 39 .
The water tank is filled.
Remark:Flooded water is not a problem.
▶ Do not put more water in the water tank.
The filter in the condensation tank is dirty.
→ "Clean the water tank filter", page 48 .
▶
Unsuitable program for the type of fabric set.
Set a time program for post-drying.
▶
→ "Programs", page 30
Power supply has failed.
Check whether the interior lighting or other devices
▶
are working.
The load amount is too high.
Observe the maximum load quantity of the
▶
→ "Programs", page 30 .
TroubleshootingNL
53
Advertisement
Table of Contents
