SECTION 2: ASSEMBLING YOUR LEAF BLOWER
This unit is shipped without gasoline or oil
IMPORTANT:
in the engine. Be certain to service engine with gasoline
and oil as instructed in the separate engine manual
before operating your unit.
NOTE: Reference to right or left hand side of the leaf
blower is observed from the operating position.
Removing Unit From Carton
•
Remove staples, break glue on top flaps, or cut
tape at carton end and peel along top flap to open
carton.
•
Remove loose parts if included with unit (i.e.,
operator's manual, etc.)
•
Cut along corners, lay carton down flat, and remove
packing material.
•
Roll or slide unit out of carton and check carton
thoroughly for loose parts.
Loose Parts In Carton
•
Upper Handle
•
Directional Discharge
•
Hardware Pack
•
Operator's Manual
Hardware Pack
This leaf blower is shipped with the following loose
parts in the hardware pack:
Hardware A
•
Curved Head Bolts (710-1174)
•
Saddle Washers (736-0451)
•
Handle Knobs (720-0241)
Hardware B
•
Hex Sems Bolts (710-0259)
Disconnecting Spark Plug Wire
WARNING: Before setting up your leaf
blower, disconnect the spark plug wire
from the spark plug and ground against
the engine.
Attaching The Upper Handle
•
Place the upper over the lower handle, aligning the
holes in the upper handle with the middle holes in
the lower handle. See Figure 2.
•
Secure with the curved head bolts, saddle washers,
and handle knobs.
Curved Head
Bolt
Attaching The Directional Discharge
(Hardware B)
•
(Hardware A)
5
Handle Knob
Saddle Washer
Figure 1
Slip end of directional discharge over chute
opening and secure with the hex sems bolts.
See Figure 2.
Directional Discharge
Figure 2
Upper Handle
Lower Handle
Hex Sems Bolt