Table of Contents
Advertisement
3.
The rope guide is attached to the right side of the upper
handle. Loosen the wing nut which secures the rope guide.
See Fig. 3-3.
C
Figure 3-3
a.
Hold blade control against upper handle.
b.
Pull starter rope out of the engine. Release blade
control handle.
c.
Slip starter rope into rope guide.
d.
Tighten wing nut.
4.
Insert post on cable ties into holes provided on the lower
handle. Pull cable tie tight and trim excess. See Fig. 3-4.
Figure 3-4
A
B
D
Grass Catcher
1.
Follow steps below to assemble the grass catcher (if
needed).Make certain bag is turned right side out before
assembling (warning label will be on the outside).
a.
Place bag over frame so that its black plastic side is
at the bottom.
b.
Slip plastic channel of grass bag over hooks on the
frame. See Fig. 3-5. All the plastic channels except
center top of bag attach from outside of bag.
B
Figure 3-5
c.
Attach center top of bag from inside of bag.
s
ectiOn
A
C
3 — a
& s
-u
sseMbly
et
p
9
Advertisement
Table of Contents
