Download Print this page

PureLink TOTALWIRE TWF2 Adjustment Procedure

Fiber termination tool

Advertisement

Quick Links

TWF2-FTT
Fiber Termination Tool Adjustment Procedure
The TOTALWIRE™ TWF2 fibers, with its patented integral 3M Polymer coating, is stronger and more bend insensitive than typical
glass fibers. The TWF2-FTT Termination Tool comes factory adjusted to cleave TWF2 fiber.
1.
Using the M2 Allen wrench included with
the cleaver, on the top right side remove
the screw that secures the fiber scrap
box. Set the scrap box aside.
2ea T10
4.
Loosen the two T10 guide screws with the
supplied wrench. Only approx. one turn is
required, do not loosen completely.
7.
Attempt to cleave TWF2 fiber. If the fiber
does not successfully cleave repeat Blade
UP steps A & B to increase blade height
until a successful cleave is achieved,
reassemble.
NOTE: If you are using a standard cleaver, perform the Blade UP steps listed above. To adjust your cleaver to cleave standard fiber perform the
Blade DOWN adjustments listed above until the cleaver no longer cleaves standard fiber, followed by the Blade UP adjustment until a successful
cleave is achieved.
purelinkav.com
2ea M2
2.
Using the M2 Allen wrench remove the
two screws that secure the guide cover.
Blade Up A
A.
Loosen the T10 hex screw located
behind the blade looking down on the
unit, counter clockwise one full turn.
Blade Down A
A.
Loosen the T10 hex screw located
behind the blade looking down on the
unit, counter clockwise one full turn.
All brand names, product names and trademarks are the property of their respective owners. Certain trademarks, registered trademarks, and trade names may be used to refer to
either the entities claiming the marks and names or their products. PureLink disclaims any proprietary interest in the marks and names of others. PureLink is not responsible for errors
in typography or photography. ©2016 Dtrovision LLC | PureLink
3.
Set the guide cover aside.
Blade Up B
B.
Turn the M2 Allen screw clockwise
2 positions. Tighten the previously
loosened T10 hex screw and the two
T10 side guide screws clockwise until
snug.
Blade Down B
Turn the M2 Allen screw counter
B.
clockwise
2
positions.
Rotate
previously loosened T10 hex screw and
the two T10 side guide screws clockwise
until snug.
the

Advertisement

loading
Need help?

Need help?

Do you have a question about the TOTALWIRE TWF2 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for PureLink TOTALWIRE TWF2

  • Page 1 All brand names, product names and trademarks are the property of their respective owners. Certain trademarks, registered trademarks, and trade names may be used to refer to either the entities claiming the marks and names or their products. PureLink disclaims any proprietary interest in the marks and names of others. PureLink is not responsible for errors purelinkav.com...
  • Page 2 All brand names, product names and trademarks are the property of their respective owners. Certain trademarks, registered trademarks, and trade names may be used to refer to either the entities claiming the marks and names or their products. PureLink disclaims any proprietary interest in the marks and names of others. PureLink is not responsible for errors purelinkav.com...
  • Page 3 All brand names, product names and trademarks are the property of their respective owners. Certain trademarks, registered trademarks, and trade names may be used to refer to either the entities claiming the marks and names or their products. PureLink disclaims any proprietary interest in the marks and names of others. PureLink is not responsible for errors purelinkav.com...