Table of Contents
Advertisement
30
www.aeg.com
Cancelling the delay start
after the countdown has
started
To cancel the delay start:
1. Touch the Start/Pause button to
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start button
repeatedly until the display shows
3. Touch the Start/Pause button again
to start the programme immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Start/Pause button to
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start button
repeatedly until the display shows the
desired delay time.
3. Touch the Start/Pause button again
to start the new countdown.
11.8 The ProSense System
load detection
The programme duration in
the display is referred to a
medium/high load.
After touching the Start/Pause button,
the maximum declared load indicator
goes off, the indicator
ProSense System starts the laundry load
detection:
1. The appliance detects the load in the
first 30 seconds, the indicator
flashes. the digit area shows
and the drum rotates shortly.
2. At the end of the load detection, the
indicator
programme duration will be adjusted
accordingly and could increase or
decrease. After further 30 seconds,
the water filling starts.
At the end of the load detection, in case
of drum overload, the indicator
flashing in the display.
flashes, the
stop flashing. The
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Start/Pause button to start the
programme again. The ProSense
System phase can be repeated up to
three times (see point 1).
Important! If the laundry amount will not
be reduced, the washing programme
.
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
About 20 minutes after the
programme start, the
programme duration could
be adjusted again depending
on the capacity of water
absorption of the fabrics.
The ProSense System
detection is carried out with
complete washing
programmes only (no
skipping phase selected).
The ProSense System is not
available with some
programmes, such as Wool,
programmes with short
cycles and without washing
phase.
11.9 Programme phase
indicators
When the programme starts the indicator
of the running phase flashes and the
other phase indicators are steady on.
E.g. the washing or pre wash phase is
running:
When the phase ends the relevant
indicator stops flashing and is steady on.
The next phase indicator starts flashing.
E.g. the rinse phase is running:
If you select the a steam programme, the
steam phase indicator
is
.
comes on.
.
Advertisement
Table of Contents
