Sony SLV-M11HF Operating Instructions Manual page 63

To check the information of a registered program
Press SMARTFILE.
The SmartFile search list appears. The registered program number,
registration date and recording time appear in this list. Note that the
registration date differs from the recorded date.
Program located in
a recorded tape
Tips
• The programs recorded on the tape can be registered again in a SmartFile label that
already contains program data. However, the recorded date and time, program
name and information input manually (such as the program label and category) are
replaced with "Program No. XX".
• If the SmartFile label contains stored program data that includes protected
programs, a message appears and registration stops.
Notes
• Program data is not registered correctly in the SmartFile label when:
• If you don't set the clock or the clock isn't set to the correct date, the registration
date won't be stored correctly on the SmartFile list.
• After you press SMARTFILE GENERATOR and start registration, registration is
interrupted if you press x STOP, H PLAY, M
INDEX SEARCH. In these cases as well, the data registered up to the point when
registration was interrupted remains in the SmartFile label.
• Tape speed may not be registered correctly when:
Downloaded from:
Estimated position of the registered program
– the program length is about 20 minutes or less in EP mode or about 7 minutes or
less in SP mode.
– the program does not have an index signal or the index signal has been recorded
over and erased.
– the tape is damaged or dirty.
– you set AUTO TAPE SPEED to ON in the ADVANCED OPTIONS menu, and the
tape speed automatically changes from SP to EP during recording.
– you use tapes recorded in the LP mode on other VCRs.
https://www.usersmanualguide.com/
p . 1
BLANK TIME 2 1 0
EP H
P r o g r am No . 6 8 / 2
0 3 0
H M
P r o g r am No . 5
8 / 2
2 0 0
H M
P r o g r am No . 4 8 / 2
0 3 0
H M
START END
M
0
Registration date
SP
0
Recording time
EP
0
EP
FF, m REW, `/1 or ./>
Smart File Funct ion
63