SkyCaddie
®
!
WArnInG! Do not use a knife or sharp object that may puncture the
battery while replacing it. If the battery is cut or punctured, DO NOT
CHARGE. Doing so may result in a hazardous condition.
To Install the Battery:
. Plug the new battery into the connector at the bottom of the circuit board. The
red wire goes on the left. The connector is polarized and can only be plugged
in one way. Do not force the connector in backwards.
. Set the battery back into the battery compartment and tuck the wires along the
top, but not under the battery, so that they do not extend past the height of the
battery or raise the height of the battery.
3. Align and connect the two halves.
4. Gently press the two halves of the SkyCaddie together and replace the screws.
5. Close rubber plug on the right-side of the SkyCaddie.
Disposal:
This device uses a Lithium-ion battery. Do not dispose of this battery with
household waste. Contact your local waste disposal agency for instructions on
proper disposal.
Belt Clip Button
The belt clip button on the back of the device is removable. Do not lose the
screw. When reinstalling, do not over tighten.
33