Points Of Interest - Suunto AMBIT3 PEAK 2.4 User Manual

Suunto Ambit3 Peak
3. Wait until the setting is completed.
4. Repeat procedure if setting fails or power POD is lost.
1.
Auto zero
Calibration
successful
150(150)
You can calibrate the slope for power PODs that use Crank Torque Frequency (CTF).
To calibrate the slope:
1. After the power POD calibration is complete, press [Start Stop] .
2. Set the correct value according to your power POD manual with [Light Lock] and accept
with [Next] .
3. Wait until the setting is completed.
4. Repeat procedure if setting fails or power POD is lost.
1.
Slope
Calibration
successful
150(150)

3.27. Points of interest

Suunto Ambit3 Peak includes GPS navigation which allows you to navigate to a pre-defined
destination stored as a point of interest (POI).
NOTE: You can also navigate when you are recording an exercise (see 3.11.7. Navigating
during exercise).
To navigate to a POI:
1. Press [Start Stop] to enter the start menu.
2. Scroll to NAVIGATION using [Start Stop] and enter with [Next] .
3. Scroll to POIs (Points of interest) using [Light Lock] and select with [Next] .
The watch displays the number of saved POIs and free space available for new POIs.
4. Scroll to the POI you wish to navigate to with [Start Stop] or [Light Lock] and select with
[Next] .
5. Press [Next] to select Navigate. If you are using the compass for the first time, you need to
calibrate it (see 3.8.1. Calibrating compass). After activating the compass, the watch starts
searching for a GPS signal and displays GPS found after acquiring the signal.
6. Start navigating to the POI. The watch displays the following information:
7. indicator showing the direction to your target (see further explanation below)
8. your distance from the target
9. The watch informs you that you have arrived at your target.
2.
Auto zero
ON
2.
Slope
10.0 Nm/Hz
3.
Auto zero
setting...
3.
Setting
slope...
41