Table of Contents
Advertisement
Figure 67
1. Lift arm
2. Hairpin cotter
7.
Remove the lift arm from the deck pin
67).
8.
Repeat steps
6
and
machine.
9.
Slide the mower deck rearward to remove the
mower belt from the engine pulley.
10.
Slide the mower deck out from underneath the
machine.
Note:
Retain all parts for future installation.
Installing the Mower Deck
1.
Park the machine on a level surface, disengage
the blade-control switch (PTO), and move the
motion-control levers outward to the P
position.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Slide the mower under the machine.
4.
Lower the height-of-cut lever to the lowest
position.
5.
On 1 side of the machine, lift the rear of the
mower deck and install the lift arm to the deck
pin
(Figure
67).
6.
Install the lift arm using the washer and hairpin
cotter
(Figure
67).
7.
Repeat steps
5
and
machine.
3. Washer
(Figure
7
for the other side of the
ARK
6
for the other side of the
8.
Attach the front support rod to the mower deck
with the clevis pin and hairpin cotter
9.
Install the mower belt onto the engine pulley;
refer to
Replacing the Mower Belt (page
g295768
47
(Figure
66).
40).
Advertisement
Table of Contents
