AEG LR9696C6 User Manual page 37

In case of in case of
drum overload, the
maximum declared load
indicator comes on again
with the
blinking. In this case,
during these 30
seconds, it is possible to
pause the appliance and
remove the exceeding
garments.
Once removed the
exceeding garments,
touch the Start/Pauze
button to start the
programme again. The
ProSense phase can be
repeated up to three
times (see point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
About 20 minutes after the
programme start, the
programme duration could
be adjusted again depending
on the capacity of water
absorption of the fabrics.
The ProSense detection is
carried out with complete
washing programmes only
(no skipping phase
selected).
The ProSense is not
available with some
programmes, such as Wol,
programmes with short
cycles and without washing
phase.
13.8 Programme phase
indicators
When the programme starts the indicator
of the running phase flashes and the
other phase indicators are steady on.
E.g. the washing or pre wash phase is
running:
indicator
.
When the phase ends the relevant
indicator stops flashing and is steady on.
The next phase indicator starts flashing.
E.g. the rinse phase is running:
.
During the washing cycle, the appliance
mixes the detergent, the stain removal
for fabric treatment and/or the fabric
softener with water before introducing
them into the drum; the indicator
appears and disappears on the display
according to the different programme
phases (the arrows flash alternatively).
If you select the Plus Steam the steam
phase indicators come on.
The steam phase is running:
The anti-crease phase is running:
.
13.9 Interrupting a
programme and changing the
options
When the programme is running, you
can change only some options:
1. Touch the Start/Pauze
The related indicator flashes.
2. Change the options. The given
information in the display changes
accordingly.
3. Touch the Start/Pauze
again.
The washing programme continues.
13.10 Cancelling a running
programme
1. Press the Aan/Uit button to cancel
the programme and to deactivate the
appliance.
2. Press the Aan/Uit button again to
activate the appliance.
Now, you can set a new washing
programme.
ENGLISH 37
MIX
.
button.
button