Cello Wave Plus 59 cm Instruction Manual page 5

GB
Berofe installing and during the installation
Check that you have all the parts and tools needed for the installation and that
the items to be installed are undamaged from the outside. Never install a faulty
item. Use protective gloves and safety glasses during the installation. The
recommended heights for hanging the cabinets are shown in the illustration A.
Assembly of suspended cabinets
Furniture should be installed onto structures and materials that can withstand
the weight of the item and the stress caused by the use. Choose fasteners
appropriate for the walling material (not necessarily included). Before using the
item, adjust the hinges and slide rails and check the tightness of screws and
joints. Make sure that the item is not going to tip over, fall or detach from the
fastenings.
Bathroom furniture maintenance instructions
The bathroom furniture should be mounted in heated and ventilated rooms
(with a temperature of +5 to +35°C and relative humidity of 30-75%). Do not
place the bathroom furniture against heating equipment.
Ensure that the bathroom furniture is not exposed to:
– The direct influence of steam on its surfaces. Furniture surfaces must be
protected from direct water splashes, for example from the shower.
– Mechanical influence (avoid striking or scratching surfaces with sharp
objects); and
– Liquid influence (clean wet surfaces immediately with a dry cloth). Many
concentrated cosmetic liquids, if spilled, can damage the surfaces if not
cleaned immediately.
All used materials can be easily cleaned. Do not use abrasive or solvent-based
cleaning products. Surfaces can be easily cleaned with soap and a damp cloth.
Damp surfaces should be carefully cleaned with a clean, dry cloth.
The porcelain sink can be cleaned with most detergents intended for household
use. However, the detergent may not contain abrasive ingredients, acids or
ammonia, which could scratch or dim the glossy surface. Please note that
hinges and slide rails should be inspected at six (6) month intervals. Then any
loose screws must be tightened and the slide rails should be cleaned and
lubricated.
Warranty terms and conditions
The warranty covers defects due to design, raw material and manufacturing
defects occurring within two (2) year of the purchase date. Defects found
during the warranty period are dealt with in compliance with the principles
defined in the Consumer Protection Act. Rectification of a defect primarily
involves replacing the product or part thereof with a similar or equivalent
product. The warranty does not cover any defect or damage caused by
incorrect installation, neglect of use or care instructions, or incorrect or
negligent handling of the item. The warranty does not cover damage caused by
normal wear and tear, such as scratches and marks, damage caused by impact
or an accident, or transport damage after delivery of the item. For all product
complaints, please contact your dealer before taking any action. Defects should
be reported within a reasonable time of detection (two months) or the moment
they ought to have been detected. The Consumer Protection Act applies to
warranty and product liability.
5