Table of Contents
Advertisement
Built-in installation
Check the minimum measurements required for correct installation of the appliance.
The coffee machine must be installed in a column unit, which must in turn be securely fixed to the wall by means of
commercial brackets.
Attention:
•
Disconnect the appliance from the mains before carrying out any installation work or servicing.
•
Kitchen units in contact with the appliance must be heat resistant (min. 65°C).
•
To ensure adequate ventilation, provide an opening on the bottom of the housing (see dimensions in Figure).
Dimensions in mm
Position the runners on the sides of the housing, as
shown in the Figure. Secure the runners with the
screws supplied, then pull them out to full extension.
If the coffee machine is installed above a "warmer
drawer", use the top of the latter as a reference for
positioning the runners. In this case, there will be no
support surface.
x 16
10
x 2
Advertisement
Table of Contents
