Table of Contents
Advertisement
VCB and VCB N C.Tec Bags 12 bar (174 psi)
Load
Page 11/22
2.5
Correct usage
Above all, C.Tec bags are a pneumatically-driven rescue device that can
be connected into a lifting system for the rescue services (e.g. fire briga-
de) and can be used to free trapped persons, create escape and access
routes and undertake similar measures. Furthermore, the C.Tec bags
can also be used as work equipment for lifting or moving loads. Lifting
heights of up to 2 m can be reached by connecting the bags into a lifting
system.
C.Tec bags in the fire-fighting sector underlie the national requirements,
DIN EN 13731. Further instruction information can be obtained from the
operating instructions of the user. The complete S.Tec system is cold-
resistant to -20 °C and heat-resistant up to +55 °C.
2.6
Safety instructions
Pre-specified personal protective clothing is to be worn during operati-
on! For example: protective clothing, safety footwear, helmet, protective
gloves, protection for eyes and face, noise protection etc.
The national regulations in connection with lifting bag systems and their
use are to be observed. For example: DIN EN 13731, national regulations.
The C.Tec Bags are only to be used with compressed air, under no cir-
cumstances are they to be used with inflammable gases or aggressively
acting gases. VCB C.Tec Bags are only to be inflated with original Vetter
C.Tec inflation fittings because these were subjected to an acceptance
test by the manufacturer. The lifting bag system is to be tested for per-
fect condition before and after use (specifications from the manufactu-
rer, national regulations).
The national safety guidelines must be observed and adhered to world-
wide.
In the Federal Republic of Germany, for example, regular safety inspec-
tions are prescribed by DGUV Principle 305-002.
Continuously shore up the lifted load with friction while the lifting pro-
cess is progressing, secure it against slipping away and, e.g., stabilise
with supports. The stable condition of foundation support material must
always be observed during construction of the foundation support. Use
only materials that are suitable for the load to be lifted such as shoring
sets made of wood or plastic or wooden beams, etc. While doing so, be
sure to comply with the max. permitted load bearing capacity of the ma-
terials.
In order to fully use the strengths of the S.Tec Bag, the distance between
load and bag should be at a minimum.
The foundation support must brace at least the
complete area of the bag and the smallest edge
length of the foundation support must be larger
than the height of the foundation support.
Metal must never be place on metal!
Attention: danger of slipping!
Advertisement
Table of Contents
