Table of Contents
Advertisement
Operations
Control panel
01 Cycle Selector
02 Display
03 Temp.
04 Rinse
05 Spin
06 Options
07 Bubble Soak
Untitled-26 31
01
Turn the dial to select a cycle.
The display shows current cycle information and estimated time
remaining, or an information code when a problem occurs.
Press to change the water temperature for the current cycle.
Press to change the rinse count for the current cycle. You can set
the rinse count to a max of 5, depending on the cycle.
Press to change the spinning speed for the current cycle.
• Rinse Hold
: The final rinse process is suspended so that
the laundry remains in the water. To unload the laundry, run a
drain or spin process.
• No Spin
: The drum does not rotate after the final drain
process.
• Spin Only
: To run the Spin Only cycle, press Spin for 3
seconds. When the cycle time and spinning speed appear, press
Spin repeatedly until a desired spinning speed is selected. Then,
press Start/Pause to start the cycle. The spinning time depends
on the selected cycle.
Press to select an option from Intensive, and Pre Wash. Press
again to deselect.
• Availability of the options depends on the cycle.
Press to activate/deactivate the Bubble Soak function. This
function helps remove a wide variety of stubborn stains.
• Bubble Soak is available with and adds up to 30 minutes to
5 cycles: COTTON, SYNTHETICS, SUPER SPEED, BEDDING and
BABY CARE.
02
03
04
05
06
10
08
11
09
07
English 31
3/27/2017 7:56:14 PM
Advertisement
Table of Contents
