Advertisement
FlavorFusion Icemaker Adaptor Kit Installation Instructions
1. Place bar into first set of pockets inside the ice bin
ICE MAKER
SUPPORT RAIL
2.
Place ice maker rail supports into the pockets in the ice bin as shown in Figure 2.
3.
Hook cross braces over top of bar and place into outer pockets inside the ice bin (at back end).
4.
Place Icemaker Adaptor Kit on top of unit.
5.
Place icemaker on top of kit. DO NOT slide icemaker into position on the lid.
6.
Apply a continuous bead of NSF International (NSF) listed silastic sealant (Dow 732 or equivalent),
supplied in kit to seal the icemaker to the top of the adapter kit. All excess sealant must be wiped
away immediately.
7.
Secure the icemaker to the adapter by drilling 9/64" diameter holes, using one of the two brackets
supplied in the kit, into both the rear of the icemaker and rear of the icemaker adapter kit. Use
extreme care not to drill into any icemaker components!!! Secure the brackets using the screws
provided.
Publication Number: 629088658INS
FIGURE 2
- 2 -
© 2005-2010, IMI Cornelius Inc.
Advertisement
