Assembly And Adjustments; Operation - DeWalt DWE305PK Manual

ENG LIS H
Description (fig. 1)
WARNING: Never modify the power
tool or any part of it. Damage or
personal injury could result.
a. Variable speed switch
b. Blade clamp lever
c. Saw shoe
INTENDED USE
Your DWE305PK sabre saw has been designed
for professional sawing of wood, metal and plastic
tubes. The compact design permits cutting
extremely close to the edge of difficult areas.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
These Sabre saws are professional power tools.
DO NOT let children come into contact with the
tool. Supervision is required when inexperienced
operators use this tool.
• This product is not intended for use by persons
(including children) suffering from diminished
physical, sensory or mental abilities; lack of
experience, knowledge or skills unless they are
supervised by a person responsible for their
safety. Children should never be left alone with
this product.
Electrical Safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated;
e
therefore no earth wire is required.
If the supply cord is damaged, it must be replaced
by a specially prepared cord available through the
D WALT service organisation.
e
Using an Extension Cable
If an extension cable is required, use an approved
3–core extension cable suitable for the power input
of this tool (see Technical Data).The minimum
conductor size is 1,5 mm
is 30 m.
When using a cable reel, always unwind the cable
completely.
6
; the maximum length
2

ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of
injury, turn unit off and disconnect
machine from power source before
installing and removing accessories,
before adjusting or changing set-
ups or when making repairs. Be sure
the trigger switch is in the OFF position.
An accidental start-up can cause injury.
Mounting the Saw Blade (fig. 2)
1. Move the blade clamp lever (b) up to release
the blade clamping mechanism.
2. Insert the saw blade into the holder (d) until it
engages. The blade can be installed with the
teeth pointing down or up, or left or right.
3. Move the blade clamp lever (b) down to lock the
blade clamping mechanism.
4. To remove the saw blade, proceed in reverse
order.
Saw Blades
material
ferrous metal
non ferrous metal
wood
plastic
masonry
A wide variety of dedicated saw blades is available
as an option.
WARNING: Always select your saw
blade with great care.

OPERATION

Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
WARNING:
• Ensure the material to be sawn is
secured in place.
• Apply only a gentle pressure to the
tool and do not exert side pressure
on the saw blade. If possible, work
with the saw shoe pressed against
recommended saw blade
fine-toothed
coarse-toothed
coarse-toothed
fine-toothed
carbide-tipped