Table of Contents
Advertisement
Suunto Ambit3 Run
3.25. Service menu
To access the service menu, keep [Back Lap] and [Start Stop] pressed simultaneously until the
watch enters the service menu.
11s
Hold to
enter
service
The service menu includes the following items:
INFO:
•
BLE: shows the current Bluetooth Smart version
•
Version: shows the current software and hardware version
•
TEST:
•
LCD test: allows you to test that the LCD works properly
•
ACTION:
•
Power off: allows you to put the watch into deep sleep
•
GPS reset: allows you to reset GPS
•
Clear data: clear recovery test calibration
•
NOTE: POWER OFF is a low power state. Connect the USB cable (with power source) to
wake up the watch. The initial setup wizard starts. All settings except time and date are
maintained. Just confirm them through the startup wizard.
NOTE: The watch switches to power saving mode when it is static for 10 minutes. The
watch re-activates when moved.
NOTE: Service menu content is subject to change without notice during updates.
Resetting GPS
In case the GPS unit cannot find a signal, you can reset GPS data in the service menu.
To reset GPS:
1. In the service menu, scroll to ACTION with [Light Lock] and enter with [Next] .
2. Press [Light Lock] to scroll to GPS reset and enter with [Next] .
3. Press [Start Stop] to confirm GPS reset, or press [Light Lock] to cancel.
NOTE: Resetting GPS resets GPS data, compass calibration values and recovery time.
Saved logs are not removed.
3.26. Shortcuts
By default, when you keep [View] pressed in TIME mode, you toggle the display between
light and dark. This shortcut can be changed to a different menu item.
To define a shortcut:
40
11s
Advertisement
Table of Contents
