Table of Contents
Advertisement
Getting Started
Before use, check appliance for visible damage. DO NOT USE THIS
HEATER if there is evidence of damage. If any damage is found,
contact Vornado Air LLC at 800.234.0604.
1. Use integrated handle for lifting and carrying.
2. Position heater so airflow is not obstructed.
3. Unwrap power cord from Cord Wrap. Plug power cord into
standard grounded wall outlet.
4. Touch Power button
and select Personal Zone Heat
Room Heat
. Next, set thermostat to desired temperature using
-/+. You may also select Fan Only by pressing
. Default settings upon first use will be Whole Room High and set
temperature of 75 degrees.
5. Upon reaching set temperature, in order to remove internal excess
heat and allow the thermostat to provide an accurate reading of
room temperature, the unit will automatically turn on and briefly
run in Low Fan mode several times per hour. If room temperature
drops below set temperature, the heater will turn back on.
COOL DOWN
When you power off your heater, it automatically enters a Cool
Down routine in which the heating element turns off and the fan
exhausts remaining heat. During Cool Down, the display counts
down from 60 seconds, then powers off completely.
Resetting Your Vornado Heater
Your Vornado Heater has a multilevel safety shut-off system
designed to prevent overheating. Overheating may occur
when the inlets or outlet are blocked. If this happens, the
safety shut-off system cuts power to the heater and you must
manually reset the heater.
1. Power heater off, then unplug power cord.
2. Remove any obstructions.
or Whole
3. Wait 5–10 minutes, allowing heater to cool down.
4. Plug in power cord and place heater in desired position.
5. Touch Power button On. Your Vornado Heater should
now function normally.
Note: If the safety shut-off system repeatedly shuts off
your heater or if it will not reset after following the above
procedure, call Vornado Consumer Services Department
toll-free at 800.234.0604.
How To Use
9
English
Advertisement
Table of Contents
