Asus PRIME N3060T Manual page 12

Internal stereo speaker header (4-pin SPK_OUT)
The internal mono speaker header allows connection to an internal, low-power
speaker for basic system sound capability. The subsystem is capable of driving a
speaker load of 4 Ohms at 3 Watts (rms).
Clear RTC RAM (2-pin CLRTC)
This header allows you to clear the CMOS RTC RAM data of
the system setup information such as date, time, and system
passwords.
To erase the RTC RAM:
1.
2.
3.
4.
Serial port connector (10-1 pin COM4)
Connect the serial port module cable to this connector, then install the module to a
slot opening at the back of the system chassis.
mSATA/mPCIe combo slot (MSATA_MPCIE)
This slot allows you to install a full length mSATA or mini-PCIe card, providing you
with expandability and connectivity solutions for an optimal system performance.
•
•
Internal DC power connector (2-pin ATX19V/12V)
This connector is for an ATX power supply. The
plug from the power supply is designed to fit this
connector in only one orientation. Find the proper
orientation and push down firmly until the connector
completely fits.
This connector supports 12V and 19V by models. Refer to the specification sheet of the
model for details.
1-4
Turn OFF the computer and unplug the power cord.
Use a metal object such as a screwdriver to short the two
pins.
Plug the power cord and turn ON the computer.
Hold down the <Del> key during the boot process and
enter BIOS setup to re-enter data.
If the steps above do not help, remove the onboard battery and short the
two pins again to clear the CMOS RTC RAM data. After clearing the CMOS,
reinstall the battery.
mSATA shares the same slot with the full-length mini-PCIe card.
mSATA shares the same bandwidth with SATA6G_2 slot. When a device is
installed on the SATA6G_2 slot, the mSATA device is disabled.
CLRTC
PIN 1
ATX19V
GND DC_JACK_IN
PIN 1
Chapter 1: Product introduction