Honda CB1000RA 2019 Manual page 134

Tire Puncture
u
NOTICE
When installing a wheel or caliper into original
position, carefully fit the brake disc between the
pads to avoid scratching them.
Lower the front wheel on the ground.
10.
Apply the brake lever several times. Then,
11.
pump the fork several times.
Retighten the right axle pinch bolts.
12.
Torque: 16 lbf·ft (22 N·m, 2.2 kgf·m).
Raise the front wheel off the ground
13.
again, and check that the wheel rotates
freely after you release the brake.
Uncover the protective tape or cloth.
14.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
132
Removing Wheels
#
Rear Wheel
Removal
Place your motorcycle on a firm, level
1.
surface.
Loosen the rear wheel nuts.
2.
Support your motorcycle securely and raise
3.
the rear wheel off the ground using a hoist.
Remove the muffler mount bolt, washer and
4.
nut.
Remove the right step bracket bolt A.
5.
Muffler mount bolt
Washer Right step bracket bolt A
Nut