Delta Hefty+ Assembly Instructions page 2

Using the Stem Mount
Remove existing stem cap from bicycle.
1
Use existing stem bolt to install Smartphone
Holder stem mount on to your bicycle stem.
Connect holder to stem mount
2
using short bolt and adjust angle
before full tightening.
1
STEM BOLT
Using the ElastoMount
Determine the most appropriate and preferential
1
position according to your riding position.
Attach ElastoMount Gear to the ElastoMount Clamp,
before attaching to Phone Holder.
2 Connect holder to handlebar clamp using short bolt
and adjust angle before full tightening.
Need help?
Email us at service@designbydelta.com
& we'll help solve your issue.
Delta Cycle Corporation 36 York Avenue, Randolph, MA 02368 USA / 800-474-6615 / www.designbydelta.com
All manuals and user guides at all-guides.com
2
IMPORTANT
SAFETY NOTE
Never loosen the stem
clamp bolts.
™
Using the Handlebar Clamp
Connect holder to handlebar clamp
1
using short bolt and adjust angle before
full tightening.
Connect handlebar clamp to bar using
2
rubber shims as needed. Tighten thumb
screw to secure the handlebar clamp
(use screwdriver if necessary).
ElastoMount
Instructions:
Easily change
angle of phone.
Switch phone from
landscape to portrait view.
3 Secure ElastoMount
to Handlebar or stem
Mounts onto any bar
up to 1 / ".
3
8
Assembly video
Visit designbydelta.com/downloads
IMPORTANT
SAFETY NOTE
Do not attach clamp
to any tapered section
of your handlebar.
1
2
IMPORTANT
SAFETY NOTE
Do not attach clamp
to any tapered section
of your handlebar.