Table of Contents
Advertisement
Water Hardness Level Adjustment Table
Hardness
English Water
Level
Hardness °dE
1
Level
st
0-5
2
Level
nd
6-9
3
Level
rd
10-15
4
Level
th
16-19
5
Level
th
20-24
6
Level
th
25-62
- Turn on the machine by pressing On / Off key while pressing and holding the
Programme Selection key when the machine is in off position. Press and hold the
programme key until the water hardness level stored on your machine is displayed
in the program indicator. Start / Pause indicator will start flashing once the stored
water hardness setting is displayed.
- By using Programme Selection key, adjust water hardness level according to the
hardness of the supply water. See "Water hardness level adjustment table" for
correct setting.
- Select the water hardness level suitable to your machine from the Water Hard-
ness Level Adjustment Table by pressing the Delayed Start Key.
- Press «Start/Pause/Cancel» key for once to store the level you have selected.
- Start / Stop icon will light continuously when the new water hardness level is
stored.
- Press the On/Off button to turn off your machine.
If the hardness level of the water that you use is above 90 °dF (French standard for
water hardness) or if you are using well water, than it is recommended to use filter
and water purification devices.
* If the hardness level of the water that you use is below 8°dF (French standard for
water hardness), there is no need to use salt in your dishwasher. If this is the case,
"No Salt Warning Indicator" (if any) illuminates continuously on the panel of your
machine.
If the water hardness adjustment is set to level 1, the "No salt warning indicator" will
illuminate continuously although it is not necessary to use salt. If you use salt under
this condition, salt will not be consumed and the lamp will not illuminate.
German Water
French Water
Hardness °dH
Hardness °dF*
0-4
0-8
5-7
9-13
8-12
14-22
13-15
23-27
16-19
28-34
20-50
35-90
Water Hardness Level Indicator
Press the Programme Selection button to set the water
hardness level to P1 position.
Press the Programme Selection button to set the water
hardness level to P2 position.
Press the Programme Selection button to set the water
hardness level to P3 position.
Press the Programme Selection button to set the water
hardness level to P4 position.
Press the Programme Selection button to set the water
hardness level to P5 position.
12 GB
Advertisement
Table of Contents
