Description: The Ocean Matrix OMX-HDCAT1X4-LR is a 1x4 HDMI HDBaseT splitter extender set that extends 4K60 signals up to 393ft. The splitter can distribute 1 source signal to any 4 display devices with its 4 HDBaseT outputs, and also features an HDMI loop out on the transmitter for local monitoring. The OMX-HDCAT1X4 also supports HDMI, Coaxial, and Analog audio extraction as well as RS-232 and EDID management.
Item Includes: 1 x Transmitter 4 x Receiver 5 x IR Blaster Cable (1.5 meters) 5 x 20K-60KHz IR Receiver Cable (1.5 meters) 5 x 3-pin Phoenix Connector 1 x 5-pin Phoenix Connector 10 x Mounting Ear 1 x 24V/2.7A DC Locking Power Adapter Operation Controls and Functions: Name Function description...
Page 4
Operation Controls and Functions: Name Function description Connect to a PC or control system via a 3-pin phoenix connector cable for the following functions: 1, Control the Splitter via RS-232 commands; 2, RS232 RS-232 signal pass-through (from transmitter to receiver or from receiver to transmitter) Connect to IR receiver cable, the IR receive signal will emit to “IR OUT”...
Page 5
Operation Controls and Functions: Name Function description Power LED Indicator Indicates when the unit is powered Service Factory use only Power Supply Input DC 24V Power supply input HDBT Input Connect to the HDBT OUT port of the HDBaseT receiver with a CAT cable HDMI OUT HDMI output port, connect to HDMI source device Audio Out...
Page 7
Operation Controls and Functions: ASCII Commands: ASCII Commands Serial port protocol. Baud rate: 115200 | Data bits: 8bit | Stop bits:1 | Check bit: 0 x - Parameter y - Parameter 2 ! - Delimiter Command Code Function Description Example Feedback Default Setting Power...
Page 8
Operation Controls and Functions: ASCII Commands: Default Command Code Function Description Example Feedback Setting Output Setting (continued) s HDBT 1 Enable HDBT output 1 stream Set HDBT output y stream on/off, y=0~4 (0=all) stream 1 ! Disable HDBT output 1 stream s HDBT y stream z! enable z=0~1 (0:disable, 1:enable)
Page 9
Operation Controls and Functions: ASCII Commands: Default Command Code Function Description Example Feedback Setting RS-232 BYPASS Setting Set RS-232 port connect to HDBT out1 s rs232 RS-232 connect to HDBT OUT1 s rs232 bypass hdbt y! Receiver RS-232 port, y=0~5 (0=all, 1~4=HDBT bypass RS-232 not connected to HDBT OUT out 1~4 5=NC)
PRODUCT SERVICE Damage requiring service: The unit should be serviced by qualified service personnel if: (a) The DC power supply cord or AC adaptor has been damaged (b) Objects or liquids have gotten into the unit (c) The unit has been exposed to rain (d) The unit does not operate normally or exhibits a marked change in performance;...