Advertisement
Installation
Mounting 1/7
The flush mount plate has holes
configured for the following mounting
conditions:
A/B
Legacy intercom back box
Direct wall mounting
C
4-gang junction box mounting
Use the corresponding holes to mount
to an existing intercom back box (A/B)
or 4-gang junction box (C).
Direct wall mounting
To mount directly to a wall, use the
mount plate as a template to mark
mounting holes (B) and the center
cutout.
Use the marks to drill pilot holes for the
mount plate. For direct mounting, drill
3mm pilot holes. When using wall
anchors, drill 6mm pilot holes.
Use the supplied screws to install the
mount plate onto the wall. Ensure that
the labels (A, B, C) on the mount plate
are facing away from the wall.
Please note: The supplied screws are intended
to cover most possible install cases. Be sure to
use the best screws for your specific job.
8
Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401
sales@verkada.com
All specifications are subject to change without notice
Copyright © 2022 Verkada Inc. All rights reserved.
Advertisement
