Table of Contents
Advertisement
eliminate the "new" smell. A little smoke due to the
protective substances applied to the heating element
before transport may be given off.
-
Position the appliance so that the plug and the outlet
can be easily reached even after installation.
-
Do not use the appliance in rooms less than 4m
area.
-
The appliance is fitted with a safety device which will
switch off it in case of accidental overheating. To reset,
please contact Customer Experience, see enclosed
guarantee.
The appliance complies with the following EC direc-
tives:
-
Low Voltage Directive and subsequent amendments;
-
EEC Directive on electromagnetic compatibility (EMC)
and subsequent amendments;
Disposing of the appliance
The appliance must not be disposed of with hou-
sehold waste, but taken to an authorised waste
separation and recycling centre.
INTRODUCTION
Thank you for choosing a De'Longhi product.
Please take a few minutes to read these instructions.
This will avoid all risks and damage to the appliance.
DESCRIPTION
(see figure on pag. 3).
A
Thermostat
B
Switches
C
Comfortemp button
D
Cord holder
E
Wheel
USE
Electrical connection
-
Before plugging the radiator into the mains, check
that the voltage of your mains electricity supply cor-
responds to the value V indicated on the appliance
and that the socket and power line are appropriately
dimensioned.
-
CONNECT THE RADIATOR TO EFFICIENTLY EARTHED
SOCKETS ONLY.
-
This appliance complies with directive on electromag-
netic compatibility.
Fitting the feet
Remove the feet and the castors from the polystyrene pack-
ing. Fit the castors to the spindles on the feet and push
firmly until they click into position (fig. 1).
Pull each castor to check that it is fitted correctly.
2
in
In certain models, the castors are already mounted on the
feet.
Using the threaded u-bolt and wing nuts, fit the feet to
the bottom of the radiator between the last two elements
as shown in figures 2, 3 and 4. Depending on the type sup-
plied, type A or type B, mount the feet as shown in figure 5.
Models with "Easy wheel" sytem
Turn the radiator upside-down on a rug or a soft surface in
order to prevent damaging the paint finish.
Fully unfold the castors by turning them outwards (Fig.6).
Turn the radiator back to its upright position.
Important!
When in use, the radiator should always be kept vertical
(wheels at the bottom, controls at the top). Any other posi-
tion could be dangerous!
INSTRUCTIONS FOR USE
Switching on
Turn the thermostat dial clockwise to maximum (6).
Turn on both switches. The lights on the switches remain on
until the room temperature reaches the set temperature,
then, they will switch off.
When the room reaches the required temperature, turn the
dial anticlockwise slowly until you hear a click and the lights
will switch off.
The appliance will come on and go off automatically to
maintain the required temperature.
-
button in position «MIN» = minimum power (indica-
tor light on);
-
button in position «MED» = intermediate power (indi-
cator light on);
-
both buttons in position «MIN» «MED» = maximum
power (indicator lights on)
Using the thermostat
The thermostat operates on the basis of room temperature
and not radiator temperature.
Turn the thermostat dial anticlockwise towards the lower
numbers to reduce the temperature; turn it clockwise to-
wards the higher numbers to raise the temperature. To turn
the appliance off completely, turn the thermostat to mini-
mum
and unplug from the mains.
11
Advertisement
Table of Contents
