Table of Contents
Advertisement
Connection
Connect to AC 220 V-
AC 240 V power supply
(TK-C9201EG/
TK-C9301EG)
(A page 8)
.
Connecting the Power Supply Cable
When power is supplied to the camera, the [POWER] lamp on the side panel
lights up.
AC24 V or DC12 V (TK-C9200U/TK-C9200E/TK-C9300U/TK-C9300E)
To prevent connection errors or a cable disconnection, use a lug plate to connect
to the terminal. The following table shows the connection distances when 2-core
VVF (vinyl-insulated vinyl sheath cables) are used. (Reference value)
Conductor diameter (mm)
Maximum connection
distance: DC 12 V
Maximum connection
distance: AC 24 V
If thin cables are used, the resistance of the cables will be high and a
Memo
significant voltage drop will occur when the camera is at its maximum
power consumption. Either use a thick cable with low resistance or
place the power supply near to the camera and shorten the length of
the cable to restrict the voltage drop at the rated current of camera to
below 10 %. If voltage drop occurs during operation, the performance
will be unstable.
Do not connect an AC 24 V cable to a commercial power supply. If it is
connected by mistake, the internal circuit may be damaged. Sent the
camera to the nearest JVC service center for inspection as the internal
circuit may be damaged.
SEE INSTRUCTION
ON
D/N AUTO
MANUAL
BLC OFF
ON
VIDEO
LCD
CRT
OUT
AES OFF
ON
MONITOR TYPE
FOCUS
ADJUST
CLASS 2 ONLY
( U TYPE )
ISOLATED POWER
SET
ONLY ( E TYPE )
AUX
GND
MENU
DC12V
AC24V
1
2
Connect to AC 24V or DC 12V
power supply (TK-C9200U/
TK-C9200E/TK-C9300U/TK-C9300E)
(A page 7)
Φ 1.0 and
more
50 m
130 m
Connection/Installation
To the terminal of infrared
illumination device etc.
(TK-C9300U/TK-C9300E/
(A page 8)
TK-C9301EG)
Monitor
(A page 8)
Φ 1.6 and
more
140 m
350 m
Φ 2.0 and
more
220 m
550 m
7
Advertisement
Table of Contents
