LG DLE6100W.ABWEECI Owner's Manual page 21

performed to alert you to any serious problems in
the exhaust system of your home.
• Your appliance features Flow Sense
innovative sensing system that automatically
detects blockages and restrictions in dryer
ductwork. Keeping ductwork clean of lint
buildup and free of restrictions allows clothes to
dry faster and reduces energy use.
NOTE
• The appliance should be cool before starting this
test. If the appliance was warmed up during
installation, run the Air Dry cycle for a few
minutes to reduce the interior temperature.
Activating the Installation Test
1
Remove any packing materials or other items
from inside the drum and close the door.
• Do not load anything in the drum for this
test, as it may affect the accuracy of the
results.
2
Press the Power button and IMMEDIATELY
press and hold the Temp. and Dry Level
buttons.
• The cycle LEDs will flicker if the activation is
successful.
3
Press the Start/Pause button.
• The appliance will start the test, which will
last a few minutes. The heat will be turned
on and the temperatures in the drum will be
measured.
4
Check the display for results.
• During the test cycle, monitor the Flow
TM
Sense display on the control panel. If the
TM
Flow Sense LED has not turned on when
the cycle ends, the exhaust system is
adequate. If the exhaust system is severely
restricted, the Flow Sense
on. Other problems may also be shown with
TM
, an
5
NOTE
• After entering the Install mode, illuminating the
• After entering the Install mode, illuminating the
• The option LED is gradually illuminated, which
Check the Duct Condition
If the Flow Sense
exhaust system for restrictions and damage.
Repair or replace the exhaust system as needed.
NOTE
• When the appliance is first installed, this test
• Do not interrupt the test cycle, as this could
• Even if the Flow Sense indicator does not light up
Error Codes
Check the error code before you call for service.
When an error occurs, various LEDs will light up
and a chime will sound.
TM
LED will turn
error codes. See the chart on the next page
for error code details and solutions.
TM
• The Flow Sense
exhaust system is severely restricted. Have
the system checked immediately, as
performance will be poor.
End of cycle.
• At the end of the test cycle, a chime will
sound and the appliance will shut off
automatically after a short delay.
Normal cycle means the heating state.
Heavy Duty cycle means the cooling state.
means that the oulet temperature is increasing.
TM
LED is turned on, check the
should be performed to alert you to any existing
problems with the exhaust duct in your home.
However, since the test performed during
normal operation provides more accurate
information on the condition of the exhaust duct
than the installation test, the number of bars
displayed during the two tests may not be the
same.
result in inaccurate results.
during the test cycle, some restrictions may still
be present in the exhaust system. Refer to the
Venting the Dryer section of this manual for
complete exhaust system and venting
requirements.
INSTALLATION 21
LED indicates that the