Advertisement
4.12.
removing a jammed nail or staple
note: You must remove any jammed nail/staple before using the tool any further. Otherwise, it could cause damage to the mechanism.
4.12.1.
remove the battery pack from the tool.
4.12.2.
open the magazine, remove the staples or nails in channel. Then, to remove the jammed fasteners.
4.12.3.
if the fasteners remain jammed after following the above instructions, slightly loosen the hex screws on the nose piece with the wrench
provided then remove the jammed fasteners pieces see bellow , only loosen these two screws , do not loosen other screws, do
not remove the whole nozzle cover.
4.12.4.
remove the jammed nail with pliers if necessary. After the jammed nail has been successfully removed , then re-tighten the nose piece
with hex screws securely.
Sometimes after a jam, the driver remains stuck and does not return to its position. Take a flat screwdriver and push it back into place.
4.12.5.
reload the staples/nails, close the magazine, then insert the battery.
Warning: Do not attempt to destroy or disassemble battery pack or remove any of its components. Also, never touch the battery
‰
terminals with metal objects and/or body parts as short circuit may result. Keep away from children.
5. maintenance
Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power
tool is maintained.
parts support is available for this product. to obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500.
environmental protection
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
Weee regulations
dispose of this product at the end of its working life in compliance with the eu directive on
Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed
of in an environmentally protective way. contact your local solid waste authority for recycling information.
Battery removal
See section 4.3
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential
purchasers of products containing batteries (as defined within these regulations), that they are registered wih Valpak's
registered compliance scheme. Jack Sealey Ltd's Batteries Producer Registration Number (BPRN) is BPRN00705.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
important: no liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
© Jack sealey limited
sole uK distributor, sealey Group.
Kempson Way, Suffolk Business Park,
Bury st. edmunds, suffolk.
iP32 7AR
Original Language Version
01284 757500
01284 703534
cPNG18 | Issue 1 22/03/17
www.sealey.co.uk
sales@sealey.co.uk
Advertisement
