Advertisement
medical attention. liquid ejected from the battery may cause irritation or burns.
make sure cord for the charger is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.
9
do not operate charging system with damaged cord or plug.
8
this tool may cause Hand Arm Vibration syndrome if its use is not managed adequately.
this tool is subject to the vibration testing section of the Machinery Directive 2006/42/EC.
this tool is to be operated in accordance with these instructions.
measured vibration emission value (a): .................. 1.39 m/s²
uncertainty value (k): ................................................ 1.5 m/s²
Please note that the application of the tool to a sole specialist task may produce a different average vibration emission. We recommend that a
specific evaluation of the vibration emission is conducted prior to commencing with a specialist task.
A health and safety assessment by the user (or employer) will need to be carried out to determine the suitable duration of use for each tool.
nB: Stated Vibration Emission values are type-test values and are intended to be typical.
Whilst in use, the actual value will vary considerably from and depend on many factors.
such factors include; the operator, the task and the inserted tool or consumable.
nB: ensure that the length of leader hoses is sufficient to allow unrestricted use, as this also helps to reduce vibration.
the state of maintenance of the tool itself is also an important factor, a poorly maintained tool will also increase the risk of Hand Arm Vibration
syndrome.
Health surveillance.
We recommend a programme of health surveillance to detect early symptoms of vibration injury so that management procedures can be modified
accordingly.
Personal protective equipment.
We are not aware of any personal protective equipment (PPe) that provides protection against vibration injury that may result from the
uncontrolled use of this tool. We recommend a sufficient supply of clothing (including gloves) to enable the operator to remain warm and dry and
maintain good blood circulation in fingers etc. Please note that the most effective protection is prevention, please refer to the correct use and
maintenance section in these instructions. Guidance relating to the management of hand arm vibration can be found on the Hsc website
www.hse.gov.uk - Hand-Arm Vibration at Work.
2. introduction
Powerful, compact cordless nail and staple gun can drive up to 50mm 18G nails or 40mm 18G staples into wood, without compressed air or
mains power supply. Robust composite housing incorporates two LED lights for use in low light areas. Selectable single or contact firing allows
use for different applications. Features an adjustable drive depth wheel for accurate results. Safety trigger device prevents accidental firing of
nails or staples. supplied in carry case with charger, battery pack and a starter pack of nails and staples.
3. specification
model no. .................................................................cPnG18
Battery ............................................................18V 2Ah Li-ion
nail capacity ..............................................20-50mm 18SWG
staple capacity ..........................................19-40mm 18SWG
replacement Battery ........................................... CPNG18BP
Weight .............................................................................. 3kg
noise Power/Pressure ......................................... 91dB/80dB
© Jack sealey limited
‰ WArninG! – risk of Hand Arm Vibration injury.
Original Language Version
cPNG18 | Issue 1 22/03/17
Advertisement
