GearLight S1000 - LED Tactical Lantern Flashlight Operation Guide

GearLight S1000 - LED Tactical Lantern Flashlight Operation Guide

Also See for S1000:

Advertisement

GearLight S1000 - LED Tactical Lantern Flashlight Operation Guide

IMPORTANT SAFETY NOTICE


Lithium-ion batteries are potentially hazardous and can present a fire, explosion, and burn hazard. By using lithium-ion batteries, you agree that GearLight shall not be liable for any incidental or consequential damages arising from, relating to or connected with the use of lithium-ion batteries. If you do not agree with these conditions, please use only alkaline or NiMH rechargeable batteries.


To avoid eye injury, do not stare directly into the light beam or shine the beam directly into anyone's eyes. Keep magnet away from children and magnetic-sensitive medical devices. Do not attach the flashlight where it is directly above any person. It may fall and cause serious injuries.

Package Contents

1x GearLight S1000 LED Tactical Lantern Flashlight
1x 18650 Battery Tube
1x AAA Battery Holder (Inside Flashlight)
3x AAA Batteries
1x Lanyard
1x Operation Guide
1x Warranty Card

OVERVIEW

OVERVIEW

GETTING STARTED

AAA Battery Installation

  1. Unfasten tail cap and remove battery holder.
  2. Insert 3 AAA batteries following the correct polarity (+,-) marked on the battery holder.
  3. Insert the battery holder back into theflashlight with the positive (+) end first.


Batteries can explode or leak and cause injury if installed backwards, disassembled, charged, crushed, mixed with used or other battery types, or exposed to fire or extreme temperatures. Replace all batteries at the same time.

18650 Lithium-ion Rechargeable Battery Installation

  1. Insert one 18650 battery inside the 18650 clear battery tube.
  2. Insert the combined 18650 battery and clear tube into the flashlight with the positive (+) end first.
    18650 Li-ion Rechargeable Battery Installation


Lithium-ion batteries can present a fire, explosion, and burn hazard. Use only 18650 battery cells with a protection circuit produced by Panasonic, Sanyo, Sony, Samsung, or LG. Remove the battery when the flashlight is not in use. The use of other cell manufacturers or the failure to follow the battery manufacturer's safety instructions may result in fire, explosion, personal injury, and damage to property.


The flashlight may become warm or hot after extended periods of use at the highest setting. Select a lower setting when the flashlight is hot. This is typical for high-powered flashlights and does not cause damage to the flashlight.

OPERATION

On/Off

  • To turn the flashlight on, press down firmly on the red power button located on the tail of the flashlight until you hear a click.
  • To turn the flashlight off, press down firmly again until you hear a click.

Switching Modes

  • There are 4 different lighting modes. (High, Medium, White Work Light, Red Work Light)
  • To access COB work light, slide both ends of the flashlight away from each other to reveal work light.
  • To switch through the different lighting modes, gently press down on the red power button to alternate through the 4 modes.

NOTE: The flashlight will start at the highest setting after being off for more than 30 seconds.

Zoom

This function only works while on the "High" or "Medium" modes.

  1. Hold both ends of the flashlight; gently twist and pull each end away from the other.
  2. Pull the two ends away from each other to zoom in and push the two ends together to zoom out.
    OPERATION - Zooming in/out

TROUBLESHOOTING

If the flashlight does not turn on, or works intermittently:

  • Replace the batteries.
  • Make sure the tail cap is twisted on tightly and batteries are inserted correctly.

If the unit flickers or changes modes automatically

  • Make sure the tail cap is twisted on tightly.

If the light appears dim or faded

  • Replace the batteries.

If the problem persists, possible LED Failure. Contact GearLight for a replacement.

MAINTENANCE

Inspect the flashlight monthly and carefully remove any damaged batteries and clean any corrosion. If the flashlight is used less than once a month, remove the batteries between uses. Lubricate all threads and rubber O-rings with petroleum jelly twice yearly.

Irvine, California | USA | www.GearLight.com

Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download GearLight S1000 - LED Tactical Lantern Flashlight Operation Guide

Advertisement

Need help?

Need help?

Do you have a question about the S1000 and is the answer not in the manual?

Questions and answers

Table of Contents