Overall Block Diagram; Overall Block Diagram - Samsung YP-P2 Service Manual

Hide thumbs Also See for YP-P2:
Table of Contents

Advertisement

Schematic Diagram
7-1 Overall Block Diagram
24pin connector
24pin connector
External Battery Pack
P5V OR USB P5V
(Alkaline 3pcs)
1.2V
2.8V
Battery Charger &
Dual Buck Converter
LITHUM BATTERY
AAT2550
3.7V_950mA
Charging: P5V OR USB 5V
400mA per channel(DDCON)
RTC
PWR
3.2V
1.8V
AAT2512
Dual Buck Conveter
400mA per channel(DDCON)
14 X 14 mm 0.8mm PITCH
ARM926 CORE (MMU) 192MHz
AD & CONTROL[24]
USB2.0 SLAVE EMBEDED
DQ[16]X2
256Mbit (32bit) * 2
AD[0-23]
100MHZ SDRAM
EDS2532EEBH-9A
DQ[0-31]
1.8V OPERATION
I2C
NAND
(DSP type)
32.768KHz
USE RTC
26MHz
MAIN CLK
7-2
INTERNAL
BOOSTER
3.0 INCH
16:9 PANEL 480X272
4 LED /18bit DATA
BACKLIT ON/OFF
Touch SCREEN
18bit PARALLEL
R:G:B=6:6:6
300 NIT
1.8~3.2V Digital I/F
3-WIRE REGISTER SETTING
TCC 7801
12MHz
MAIN CLK
256 BALL BGA
32.768KHz
0.40 ~ 0.45mm BALL PI
RTC XTAL
HEADPHONE
EAR JACK(3.5 PI)
RTC Module EMBEDED
AUDIO CODEC
I2S I/F
WM1808L
1.8V CORE
I2C 0
2.8V I/F
3.1V ADC
2.8V DAC
I2S
GPIO
UART
B/T ANT
BLUE TOOTH MODULE
with FM_MODULE
BCM2048 SKUFBG
This Document can not be used without Samsung's authorization.
 The Main System consists of such basic circuit blocks as Processor (TCC7801), SDRAM (32Mbit), Flash Memory,
Power Block, and Audio DAC, and includes FM_Tuner, Bluetooth Block, and LCD Block.
 Serial interfaces between the IC's are implemented with various protocols throughout the system.
The Host Processor (TCC7801) and the UART are used to implement the Audio DAC and the FM Tuner, the interface
between the Bluetooth Module and the Host Process is accomplished by the UART, and the Audio DAC accomplishes
mode setting and data transfer through I2C and I2S, respectively.
 Power can be turned on and off with the power switch on the side of the device. Either the built-in battery or the power
adapter can be used for power supply. The power adapter is capable of 5V input. The power from the power adapter
charges the battery at AAT2550. Four (4) different voltages required are 2.8V (Main), 1.07V (CPU Core), 1.8 (SDRAM
Memory), and 3.1V (WQVGA LCD).
FM ANT
Samsung Electronics

Advertisement

Table of Contents
loading

This manual is also suitable for:

Yp-p2jcb/xeoYp-p2jqw/xeo

Table of Contents