Advertisement
● This manual is only for reference and does not
ensure that the information is totally consistent
with the actual product. For consistency, see the
actual product.
1. Package Contents
Open the package, check the appearance of the
product for no obvious damage, and confirm the
item list for table 1-1 is consistent.
Table 1-1: Packing List
Component
Bullet Network Camera
Setup & Support Insert
Installation Location Sticker
L Hex Wrench
Stainless Self-tapping Screw
PA4.0×30mm
Swell Plastic Button
φ5.6×29mm
Waterproof Rubber Seal
Video Patch Cord
Green Terminal Block 4 PIN
2. Device Structure
Camera Dimensions
Note: Different devices may have different dimensions;
please refer to the actual product.
Figure 2-1: Dimensions (Units: mm)
Quantity
Remark
1
1
1
Optional
1
4
4
1
1
1
Optional
3. Device Installation
The Bullet Network Camera can be installed on
the ceiling or wall. You can select an installation
mode based on site requirements. If the camera
is installed on a concrete wall, install the
expansion bolts before installing the bracket. If
the camera is installed on a wooden wall, use
self-tapping screws to install the bracket
directly.
Installation Steps
1.
Stick the installation location sticker on the
ceiling or wall, and drill three holes based on
the marks on the sticker. Drive the swell
plastic buttons into the holes.
2.
Connect the multi-connector cable.
Note: you can route cables from the top or from a side. If
you use the top routing method, drill a hole in the surface
first. If you use the side routing method, route the multi-head
cable out from the side gap at the bottom of the camera.
3.
Install the camera on the ceiling or wall using
the screws as shown in figure 3-1.
Figure 3-1: Installing camera
4.
Loosen the fixing screw and lock ring to
adjust the camera position so that it faces
the monitored area, then tighten the lock ring
and fixing screw, as shown in figure 3-2.
Advertisement
