Advertisement
Quick Links
24V Battery Charger
Model No. 88503
Model No. 88504
Model No. 88505
Charging the Battery Pack
1. Turn the battery upside down and line up the battery
terminal with the slot in the charger (Figure 1 and
Figure 2).
1
1. LED indicators
LED COLOR
Left
Red
Red
Red
Red
Red (blinking)
© 2011—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
2
G017407
Figure 1
2. Insert battery here
Right
Red
Green
Orange
Green
Red (blinking)
Register at www.Toro.com.
3
Figure 2
1. LED indicators (level of
charge)
2. Release button
2. Slide the battery into the charger until it clicks into
place.
3. To remove the battery, press down on the release
button and slide the battery backwards out of the
charger.
4. Refer to the table below to interpret the LED
indicators on the battery charger.
Indicates:
Battery is charging
Fully charged
Battery is too warm: Remove for
approximately 30 minutes
No battery present
Defective battery
Form No. 3371-424 Rev A
Operator's Manual
2
G016223
3. Battery terminal
Original Instructions (EN)
Printed in China
All Rights Reserved
1
Advertisement
Related Manuals for Toro 88504
Summary of Contents for Toro 88504
- Page 1 Form No. 3371-424 Rev A 24V Battery Charger Model No. 88503 Model No. 88504 Model No. 88505 Operator's Manual Charging the Battery Pack 1. Turn the battery upside down and line up the battery terminal with the slot in the charger (Figure 1 and Figure 2).
- Page 2 Inserting the Battery into the 2. Grasp the trimmer handle. Trimmer 3. Push the battery pack into the handle until the latch locks into place. 1. Align the tongue of the battery pack with the cavity Important: The battery pack is not fully in the handle housing (Figure 3).